Tools of the trade 13: Saws

Others have written whole books about saws, tooth geometry, how to use, the various advantages of different types of saws… so instead of writing a book here I’ll tell you to go read a few.

Not even with a table saw can you get away with only having one type of blade. So you need to have a few Saws in your arsenal.

P1010012
a few frame saws
P1020602
some panel saws and back saws

You need a good crosscut saw. these are for cutting stock to length.

5 tpi Rip saw on top, 6 tpi crosscut on bottom. Compare tooth shapes

You need a good rip saw, these are for cutting stock to width.

P1020601
Spears and Jackson 4tpi rip saw

Now, a lot of our stock sizing is done with splitting and hewing. So maybe a ripsaw isn’t as critical as having a crosscut saw. But you will eventually find a place where you want to cut a slab of wood in the rip direction and cannot spare the waste of splitting and hewing. So when you get a Ripsaw make sure it is a good one. (this one is an antique Spears and Jackson that I found, 4 tpi rip)

For cutting tenons you will want a crosscut saw, you could use your big one for cutting stock down, but you will find that having a smaller one, perhaps with a back stiffener, to be very handy for this… these are called Back saws.

P1020603

a coping saw is handy for small stuff and some curved cuts. This is a saw frame that I made; it takes new coping saw blades.

P1020604

A Turning saw is good for large curved cuts.

So is a Felly saw.

and for resawing slabs to make thinner boards a big ripping frame saw or just your ripsaw can be used.

and the saw nib is just a decoration.

be well

PS you know about the “nib” on the tip of some saws? This is where it comes from:

ebaa4a55c7f6f0d74825ce3b11cd83c0

You can see the nib on this very old saw, as well as several decoratively shaped holes. When this saw was new, the Dutch and the Flemish saws were considered superior to all others, and they cut some decoration into the tips. more recently Disston (and others) were doing the same, putting a nib on the saw to indicate it was “the best”.

Leave a Reply